ENGLISH
PIKUS 105/105DL – PIKUS 75/75DL
11
Jolly 45° Operation
BEFORE PERFORMING ANY OPERATION, MAKE SURE THAT THE MACHINE IS
UNPLUGGED.
As far as the DeLux version is concerned,
remove the tile-holder device from the left-hand
side of the machine, by means of the wing nuts,
and fix it to the right-hand side; tighten the wing
nuts after adjusting.
•
Loosen the column lock knobs (A) (front and
back), tip the guide bar all the way and lock it by
firmly tightening the column lock knobs.
•
Position the motor head so that the diamond strip
is flush with the work surface.
IMPORTANT: BEFORE CUTTING, MAKE
CERTAIN THAT THE COLUMN LOCK (A)
AND THE MOTOR HOIST (B) KNOBS
ARE FIRMLY TIGHTENED.
ATTENTION: BEFORE TIPPING THE
SLIDE BAR, MAKE CERTAIN THAT THE
DIAMOND DISK DOES NOT TOUCH ANY
PARTS OF THE MACHINE OR THE MA-
TERIAL TO BE ROUNDED OFF.
•
Position the tile to be rounded off with the glazed
side facing upwards on the work surface and
make certain that it rests perfectly on Square (C).
•
Check that the diamond disk is flush with the
glazed surface.
•
Bring the triangle (D) up against the tile and lock
in place with the knob (E).
•
Run a Jolly test. Make any fine adjustments by
loosening the lever (E), adjusting and tightening it
again.
To perform the Jolly 45° cut properly, the diamond
disk must be well sharpened; if not properly
sharpened it would bend and the cutting line would
not remain flush with the glazed surface.
If the end of the tile (the last centimeter) breaks,
sharpen the diamond disk.
If this does not eliminate the problem, it can be
resolved as follows:
•
if you need to round off on side (F), bevel 2-3 cm
on side (G) of the tile.
•
then turn it and round off side (F)
.
F
IG
.
10
F
IG
.
11
E
F
G
A
B
C
D
Summary of Contents for PIKUS 105
Page 1: ...GB...
Page 2: ......
Page 16: ...PIKUS 105 105DL PIKUS 75 75DL ENGLISH 16...
Page 19: ......
