20
ESP-LXD Controller
Station Setup
The Station Setup Wizard tells the ESP-LXD controller how many and
what type of stations are used by your irrigation system.
Each valve within an irrigation system is referred to as a station. Be sure
to note the location of each station on the Programming Guide so they
can be set up correctly in the controller.
The ESP-LXD controller also supports station setup by scanning decoder
barcode labels using the optional Programming Backup Cartridge
(PBC-LXD). See Section E for more details.
b
b
NOTE:
Before setting up stations, follow the previous instructions
to set up valve types, master valves and weather sensors (if
present).
b
g
Turn the controller dial to Setup Wizards.
A
The Setup Wizards screen appears. Press the Down Arrow button
to select Station Setup then press Next.
B
The Station Setup screen appears. Press the + and – buttons to
enter the desired station number; then press Next.
1
2
C
Press the + and – buttons to enter the decoder address, pressing
Next and Back to navigate between the number setting fields;
then press Next.
b
b
NOTE:
An alarm will show if a duplicate decoder address is
entered for more than one station. See Section A, Alarm Conditions
for more details.
D
Press the + and – buttons to select the type of valve you’re using
for this station; then press Next.
3
4
Summary of Contents for ESP-LXD
