Installation
ENG
ESP-Me Controller
10
Connect Rain/Freeze Sensor (optional)
The ESP-Me controller can be set to obey or ignore a
rain sensor. Refer to the Rain Sensor section under
Advanced Programming.
A
Remove the yellow jumper wire from the SENS
terminals on the controller.
c
b
NOTE:
Do not remove the yellow jumper wire
unless connecting a rain sensor.
B
Connect both rain sensor wires to the SENS
terminals, as shown.
c
c
WARNING:
Do not route the rain sensor wires
through the same opening as the power wiring.
c
b
NOTE:
Rain Bird controllers are only compatible
with normally closed rain sensors.
c
b
NOTE:
For wireless rain/freeze sensors, refer to
installation instructions for sensor.
B
Summary of Contents for ESP-Me
Page 139: ...This page intentionally left blank...
