12
STEP 4: Set the length of watering time per station
Each station on the PC-200 series can be set to water from 0-99 minutes, in
one minute increments. When shipped from the factory, all stations are preset to run
for 10 minutes on program A only. If a station is watering on both programs, you can
set different minutes for the same station on each program.
How to set station run times
PGM
A
/
C
4-A: Setting the run times per station
Remember, the station number is shown as the first digit in the display. The program is the second digit,
and the run time is represented by the last two digits.
Press
Once
and change
station 1
by pressing:
Station 1
Program A
10 minutes
OR
PGM
A
/
C
To advance to station two, follow this step:
Press
Again
and change
station 2 by
pressing:
Station 2
Program A
99 minutes
OR
STATION
TIMING
STATION
TIMING
STATION
TIMING
Repeat this step for stations 3 through 6.
PGM
A
/
C
4-B: Removing a station from a program
This is the step that determines whether a station will run on program A, Program C, or both. If you do
not want the station to operate, you must set the run time to “00.” The timer will then skip this station.
Press
Again
and remove
the station
by pressing:
Start #3
Program A
No time
OR
When the right two digits change to 00, the station will be skipped. In this example, Program A
would skip station 3 and go to station 4.
STATION
TIMING
IMPORTANT!
On any program, if you do not want a a station to water, you must set the station to “00.”
Any station not set to “00, ” will follow the normal program watering schedule.
After programming the last station, the display will show “0 00.”
Press SET CLOCK to return to the normal time of day display:
