4
VALVE AND TIMER CONNECTIONS
TERMINAL
BLOCK
DIRECT
BURIAL
CABLE
WIRES TO
ZONES 3 & 4
POWER
POWER
COMMON WIRE
WATER-TIGHT
CONNECTORS
ZONE 1
VALVE
ZONE 2
VALVE
Step 4. Verify System Operation
Battery Pull Tab
To activate the internal battery, grasp the yellow pull-tab
on the side of the timer and pull it out.
Apply Power
Indoor Model
Plug the transformer into a wall outlet.
Outdoor Model
Turn on main power supply or plug the power cord into a
waterproof receptacle.
NOTE:
Do not plug the timer into a socket that is con-
trolled by a secondary ON/OFF light switch or GFI outlet.
Test Watering
Turn the dial to the
ZONE 1
position.
"
"
Press the
WATER ONE ZONE NOW
button. The zone
should start watering for a default run time of 10 minutes.
To stop watering before time is up, turn the dial to the
next position.
Repeat the above steps until all zones have been tested.
Replace the wiring bay cover on front of the unit.
REMOVE
PULL-TAB
OUTDOOR
APPLY
POWER
INDOOR
PLUG IN
TRANSFORMER
TEST
WATERING
