NOTE:
Please refer to the section heading “Surface Material”
before installing the Rain Deck housings.
If your supply lines have concrete sleeves, pull the sleeves exposing
the concrete around the ½” risers. Cut the
½” PVC pipe to accommodate the proper
installation of the Rain Deck housing. The
½” riser should be cut so that when the
housing is installed, the top of the housing
will be flush with the top of the finished
surface material (ie. If ½” rubber surfacing
will be applied as a surface material, set the
housings ½” above the finished concrete).
After the Rain Deck housing has been connected to the supply line,
use mortar or a similar concrete
product to fill the void around the
housing. As the mortar sets up,
use a level to ensure that the
housing is level.
Take proper precautions to ensure
concrete or other debris does not get into the Rain Deck housing.
Your Splash Pad Product and Installation Resource
Housing/Nozzle Installation
