Rain Master Irrigation Systems
DX2 User Manual
Appendix A: Flow Meters
Page 233
Flow Meter Operation Overview
In order to display flow rate and/or flow accumulation data:
a.
Insure flow sensor/meter has been properly connected
Refer to Flow Sensor Installation Instructions
b.
Establish the appropriate flow calibration criteria, see
"Flow Meter Offset and K Values
In order to establish flow limit checking either on a controller or
individual station basis, verify the following:
c.
Steps a and b (above) have been performed.
d.
Station Upper Limits have been established, see "Max
Flow Limit".
e.
Station Lower Limits have been established, see "Flow
Limit" page or "Auto Limits".
f.
Main flow limits have been established, (see "Main
Flow".
g.
Total Monthly Flow has been set, see "Flow Options".
h.
Unscheduled Flow Limit has been defined; see
"Unscheduled Flow Limit".
i.
The upper and lower limit checking is enabled; see
"Enable/Disable Limit Checking".
j.
The appropriate flow limit check delay has been
established, see "Delay Limit".
k.
Selection of either one or two flow meters, see
"Flow Meter Compare Limits".
