Rain Master Irrigation Systems
Weather Center II User Manual
Page 55
8.6
Wind Speed Sensor Verification Procedure
8.6.1 At the Evolution DX2 Controller
This procedure assumes that the wind sensor inputs 4 (+) and 4 (-) on the
Sensor Terminal board are functioning properly.
Proceed to the Rain/Wind display through the following menu
sequences:
RAIN = 000.01/INCH
WIND = 000 MPH |
↑
|
F1 = Main Menu
F3 = Status
F2 = Measurements
F5 = Rain/Wind
Step 1
If windy conditions exist, allow the anemometer to spin in
the wind and observe the wind speed reading on the
display. It may take up to a minute before the display
begins to register a reading.
Step 2
If no wind conditions exist, the anemometer cup assembly
must be operated manually. This may require two people,
one to operate the cup assembly for at least one minute
and a second person to observe the wind speed reading.
If a reading is still not displayed, the problem is in the
anemometer or its associated wiring. Check all wiring and
connections from the anemometer to the controller.
An updated displayed reading indicates that the
anemometer is operating properly.
Step 3
If wind speed reading problems still exist, please contact
the factory.
Summary of Contents for Weather Center II
Page 1: ...Weather Center II User Manual Part 500009 Rev D...
Page 2: ...Weather Center II...
Page 3: ......
Page 7: ......
