A
H30
H3
H11
H133
H129
N380
N406
*NOTE: Depending on set configuration, Chin Up Bar may be mounted on either Monkey
Bar arm.
*NOTE: The Chin Up Bar can be mounted on both the 4x4 and 4x6 Monkey Bars. 3/8"
Hardware (H129) will be used if mounting the Chin Up Bar on the 4x4 Monkey Bar.
*NOTE: Installation processes will be the same if mounting the 2 Hole Mount Chin Up Bar
(N380) or the 4 Hole Mount Chin Up Bar (N406).
1. Hold Chin Up Bar
(N380) (N406)
on underside of Monkey Bar in approximate location shown. Make
a mark in center of both holes in Chin Up Bar
(N380)
, or all four holes of the Chin Up Bar
(N406)
.
*NOTE: Be sure when positioning Chin Up Bar, drill holes will not hit Rungs in Monkey Bar.
2. Drill holes through Monkey Bar, on previously made marks, using a
7/16" drill bit
.
3. Attach Chin Up Bar
(N380) (N406)
to Monkey Bar using 3/8" Hardware
(H3) (H11) (H30) (H133)
.
*NOTE: 3/8" Hardware (H129) will be used in place of 3/8" Hardware (H133) if installing the
Chin Up Bar on the 4x4 Monkey Bar.
*NOTE: A small hammer or mallet may be needed to pound in 3/8" Hardware (H30).
95
Step 54
Chin Up Bar
Installation
