7
Start ironing the garments requiring a low temperature.
This reduces the waiting times (the iron takes less time to
heat up than to cool down) and eliminates the risk of scorching the
fabric.
Filling the reservoir
- Check that the plug is disconnected from the socket.
- Press the (C/Picture 1) button, pull the water tank up.
- Open the lid, slowly pour the water into the water tank and taking
care not to go over the maximum level indicated by “MAX” on the
reservoir.
- Close the lid and put the water tank on place till click sound.
SELECTING THE TEMPERATURE, DRY IRONING
- Put the iron in a vertical position.
- Put the plug in the socket.
- Adjust the thermostat knob (E/Picture 1) according to the
international symbol on the garment label [Table 1.]. The plate
temperature control light (F/Picture 1) indicates that the iron is
heating up. Wait until the plate temperature control light goes off
before ironing.
Warning:
during ironing, the plate temperature control light (F/
Picture 1) comes on at intervals, indicating that the selected
temperature is maintained. If you lower the thermostat temperature
after ironing at a high temperature, do not start ironing until the plate
temperature control light comes on again.
SPRAY FUNCTION
Make sure that there is water in the water tank. Press the spray
button (B/Picture 1) slowly (for a dense spray) or quickly (for a
vaporized spray).
EN
Summary of Contents for MR-312C
