RainDrop Sense Operator’s Manual
LCN 50-04344 Rev. D
4-14
Alarms, Log, and Status Tabs
The Alarms, Log, and Status tabs are displayed on the bottom of the screen (see
). Each of these tabs is described below.
Figure 4-11: Example of Screen Showing Alarms, Log, and Status Tab at Bottom
The
Alarms
tab is displayed by default. Click
Log
or
Status
to display that tab.
Alarms Tab
–
This tab lists instrument errors that exist in the system. If an error
appears, the system is in a warning or error state. Different errors occur during the
setup of the instrument. If an error does not clear when you close the door and click
Start Run
, check
. If the issue is still not resolved,
contact
support@raindancetech.com
for assistance.
Log Tab
– This tab is used for service purposes. It is used to check on the system
automation.
Status Tab
– This tab is used for service purposes. It is used to determine the status of
the instrument at different points during operation.
