RainDrop Sense Operator’s Manual
LCN 50-04344 Rev. D
4-13
Completing a Process
When you have completed each step to prepare for a run, review the System Status
indicators. Ideally, all the status indicators will be green check marks, although you can still
continue with orange exclamation points since they indicate only that optional fields are
blank. The process cannot be started if there is even one red X (error indications) on any of
the tabs.
When you are satisfied that the steps for the process are complete, click
Start Run
on the
bottom right side of the
Run Data
tab. This starts the process on the RainDrop Sense
instrument.
Figure 4-10: Start Run Button
Using Scan Buttons
The ICS allows you to scan barcodes to enter information into various text fields. There are
two types of Scan buttons available in the system as shown in
Table 4-4: Scan Buttons
Button
Description
Use
Manual Scan Button
The instrument requires that you
manually enter a barcode.
Scan Button
The system allows you to scan any
type of barcode.
Clicking either type of scan button activates the barcode reader on the system and allows you
to scan the barcode.
If you scan the wrong type of barcode, an error message appears. ICS will not accept an
invalid barcode.
