RainDrop Sense Operator’s Manual
LCN 50-04344 Rev. D
5-10
Completing the ICS Setup
Before starting a run on the Sense instrument, you must complete a number of setup steps.
The steps ensure that the instrument is ready for operation and provide data about the run.
They include:
Check the status of various components.
Complete the Run Data.
Complete the Run Info.
Checking the Status Indicators
Status indicators tell you about the readiness of the instrument.
Figure 5-10: System Statuses
Observe the status indicators in the software.
Table 5-1: System Status Indicators
Indicator
Meaning
Pressure
Ready
Indicates the status of the instrument gas pressure. When the pressure is
sufficient, the ready indicator is displayed.
Carrier Oil
Indicates the status of the carrier oil reservoir. When there is sufficient oil
to complete a run, the ready indicator is displayed. A valid carrier oil lot
number is required for the green check mark to be displayed.
Drive Oil
Indicates the status of the drive oil reservoir. When there is sufficient oil to
complete a run, the ready indicator is displayed. A valid drive oil lot
number is required for the green check mark to be displayed.