RainDrop Sense Operator’s Manual
LCN 50-04343 Rev. D
7-6
Service and Diagnostic Requirements
The system checks its status at start-up automatically. The ICS application prevents
runs when it detects a system failure or not ready condition.
The hardware is designed to facilitate field replacement of subsystems and/or
subsystem components as required.
There are no user serviceable parts inside the RainDrop instrument. For safety
reasons, those components have limited access.
All technical maintenance or service is provided by RainDance Support.
Powering Off the System
Follow this sequence to turn the system off:
1.
Exit the ICS application. Wait 10 seconds.
2.
Power off the instrument by turning off the switch on the rear of the instrument.
3.
Power off the IC Workstation by selecting the
Start
icon and then selecting
Shut
down
.
4.
Press the
Power
button on the monitor to turn it off.
Powering On or Restarting the System
Refer to
“Starting the ICS Application” on page 4-2
.
Restoring the System After a Failure
In most cases, the RainDrop instruments automatically reset after a failure. You can start
subsequent runs without manual intervention.
