12
Filling:
Water level is centered in area of weir door or 1 inch above extended skimmer opening.
Never fill past the recommended level. Check to see if all slice valves are open. The slice
valves should have the handles pulled out as far as possible when open. The drain bib
should be closed and drain cap installed. Fill your spa with water by removing you filter lid
(all models may not have a lid) and place the garden hose into the filter housing. This will
help prevent air from being trapped in the plumbing lines commonly known as an air lock.
Jets, Valves and Air Controls
Jets
The jet inserts in the spa that have a textured feel are adjustable allowing you to increase or
decrease the water flow by turning the jet face clockwise or counterclockwise. This makes
it easier to get the right pressure needed in the right areas. Jets with a smooth face are not
adjustable. Please try adjusting the jets to acquire the proper technique.
Slice Valves
These valves allow removal of equipment without having to drain the spa. The T-handles
should always be in the open position, allowing water flow before operating the spa. The
slice valves are located on the intake and discharge sides of the pump(s) they will be placed
down in closed position.
Air Control Valves
Turning the valve counterclockwise increases the airflow and the pressure of the jets.
Turning the valve clockwise will control the air supply for less pressure. All Air Control
Valves are located on the top of the spa and used to control the amount of air that mixes
with the water flow of the jets.
Waterfall Valve
By turning the handle counterclockwise the water flow will decrease. By turning the
handle clockwise, the water flow will increase. The Waterfall Valve is located at the top of
the spa and is similar to the air control valve.
Diverter Valve
This valve allows you to increase or decrease pressure ( by turning handle from side
to side) in certain areas of the spa. The diverter valve can balance jet pressure throughout
the spa. The Diverter Valve is located on the top of the spa and is large in size to left corner
of keypad. Diverter Valve can only be moved when the pump(s) are turned off. Otherwise,
damage will occur to the diverter valve.
