15
8.
To gain access to the spa’s power terminal block, remove the screws and cabinet
panel setting it aside, then remove the securing screws from the panel on the control
equipment pack system.
9. Select the power supply inlet you want to use and remove the cabinet panel from the
front of the spa to allow you to feed the cable through to the control box. Install the cable
with connectors through the conduit.
10.
Connect wires, color to color, on terminal blocks and TIGHTEN SECURELY! All
wires must be hooked up securely or damage could result.
11.
Install control box door panel with screws and re-install the cabinet side panels.
Filter Maintenance
The filter(s) in your spa should be cleansed at least every 5-6 weeks, depending on spa
usage. This will ensure that the water is being filtered properly, and there is no restriction in
the filer due to dirt and grease build-up.
Cleansing the filter can be done easily using a Filter Degreaser solution and following the
directions on the bottle. Soak filter in a degreaser and power wash with a garden hose. It is
recommended to have a second filter, which can be cleaned between filter changes. This
will enable you to quickly exchange the dirty filter with a clean filter and immediately start
your spa up again.
Filter Removal: The filter system is the top-load type. This style is round, approximately
8” in length located in the corner of the spa below the water level when the spa is full). To
remove basket turn counterclockwise ¼ turn removing the basket and lid, to re-install turn
lid clockwise and lock into place.
Cleaning Filter (s): There are a few ways to clean your filter. A very effective way is to use
a garden hose and nozzle with good water pressure. Start at the top of the filter spraying a
side-to-side pattern downward, turning filter as necessary. It is recommended to clean filter
(s) every month depending upon activity in the spa. Speak to your dealer about other
methods of cleaning spa filters. Replace your filter (s) about every 6 months depending on
activity. If your spa stops heating, please check to make sure the filter (s) are clean and free
of debris before contacting the dealer.