Raindrip R675CT Installation & Programming Download

Page: 6 / 6

Troubleshooting

Visit Raindrip.com/timers

Water does not come on:

POSSIBLE PROBLEM

SOLUTION

Water off

Turn water on

Battery power low

Replace batteries

Batteries not installed

Correct battery

properly

installation

Run time is longer or

Increase Frequency

the same as Frequency

or reduce run time.

(Example: If Frequency dial is set to 1-hour,

then Run Time dial must be 30 minutes or less.)

Winterize: remove from faucet, remove batteries and store indoors.
Warranty: Limited three year warranty from date of purchase.

(original receipt required for warranty claim)

2855 S. East Ave.
Fresno, CA 93725
Technical Service: 888-825-4716

Summary of Contents for R675CT

Page 1: ...Installation Programming Video available on Raindrip com timers R675CT ...

Page 2: ...Tool Free Installation Tip Must have minimum of 15 PSI at hose bib Visit Raindrip com timers Hose Bib Timer Hand Tighten ...

Page 4: ...ted Tip Firmly push down on the battery tray to ensure it is clicked into the timer Visit Raindrip com timers 1 Make sure you have 2 Alkaline AA batteries not included 2 Load the batteries as shown Timer Batteries ...

Page 5: ...e program will resume in 48 hours Manual Watering Manual Mode Watering in between scheduled programming From RESET position turn dial to desired Manual Water setting The example shows the timer will water manually for 30 minutes Automatic watering will resume automatically after manual mode is complete Tip Manual light will flash when in Manual or Rain Delay modes ...