raindrip.com/weathersmart
Installation & Programming
9
Wiring the Docking Station
These instructions assume your irrigation system is properly installed and
the valve solenoid wires are available at the timer mounting location.
CAUTION: Do not connect more than one wire to each
terminal. Damage to the timer will occur.
Common Wire Connections
•
Insert the common wire from the solenoids to either "COMMON"
terminal (white) at the bottom of the docking station.
Zone Wire Connections
• I
nsert one control wire from a specific solenoid (zone 1) to
a corresponding "ZONES" terminal (blue 1) at the bottom
of the docking station. Repeat for each zone solenoid.
•
Check wires to ensure they
are fully seated and secure.
•
Plug A/C Power Suppy connector to
the "24 VAC POWER" terminal (red),
then plug the Power Supply into a
110 volt outlet.
Installation: Wiring
Docking the Timer
• Install AA batteries in the back of the timer.
• Place the back of the timer against the docking station
•
Slide the timer downward until it is firmly seated at the
bottom of the docking station.
•
Confirm UNDOCKED indicator is turned off.
The timer is ready for programming and operation.
Installation: Dock Timer
raindrip.com/weathersmart
Installation & Programming
10