Press Wheel Adjustment
Press wheels need to run at the bottom of the trench and not on the
side to stretch the plastic properly. Adjust the position of the press
wheel using pin (A).
After bed height/width is changed press wheels need to be adjusted
according.
The spring provides down pressure on the press wheel and is
important for Auto-Start. Adjust the down pressure by using pin (B).
Avoid excessive spring tension which can cause the plastic to tear.
Plastic Tension
Plastic rolls have a tension brake.
Just a slight tension is needed.
Setting brake tension too tight
may affect the performance of the
machine and can cause plastic to
pull out from under press wheels.
Tension
Brake
Adjustment
10
A
B
