PROBLEM Machine tends to drift sideways causing disks to cut into
plastic mulch.
SOLUTION * Pull less soil. Pull just enough to fill a firm bed.
* Adjust 3-point top link and/or compression rate (page 7).
* If your machine has Manual Ro-Trak, make sure the sway
bar is in place and machine centered.
* On Auto Ro-Trak machines, make sure Ro-Trak is
functioning properly.
* Tractor may be too small.
PROBLEM Cover disks not getting enough soil to cover plastic.
SOLUTION * Tilt disks back to dig in more (page 12).
* Adjust front disks deeper or move to back setting (page 13).
PROBLEM Plastic edges not staying under press wheels.
SOLUTION * Tension too tight on plastic roll carrier (page 10).
* Adjust press wheels closer to bed (page 10).
PROBLEM Ro-Trak not functioning.
SOLUTION * Follow Ro-Trak information, page 14 and 15.
PROBLEM Beds aren’t firm or have hollow spots in center.
SOLUTION * Tractor’s 3-point or draft control might be lifting up.
* Adjust front disks deeper or move to front setting (page 13).
* Use less compression (page 7).
* Soil not tilled deep enough for bed height.
1.
2.
3.
4.
5.
18
TROUBLESHOOTING
Call customer service at (717) 445-3000 with any other questions or feedback.
