EAGLE-200
™
User Manual
17
EAGLE-200 Hardware Ports
On the back of the EAGLE-200 there are three interface ports and three switches.
From right to left, these are:
•
Ethernet
– The included Ethernet cable plugs into this socket. The other end of
the cable plugs into the local network router. This should be plugged in first
before plugging the power in.
•
USB
– This socket can be used to expand the functions of the EAGLE-200.
Nothing should be plugged into this socket.
•
Power
– The included AC power adapter connects to this standard micro-USB
socket. The other end of the adapter plugs into a nearby power outlet.
It is
important that only the included 5v adapter is used to power the EAGLE-200. If
another adapter is used, it may cause permanent damage to the unit
.
•
Switch 3
– This switch should not be used.
•
Switch 2
– this small hole provides access to a reset switch for the Zigbee
Endpoint radio.
This switch should only be used under the direction of a
Rainforest support engineer, as it will cause the Zigbee radio to break its
connection to the meter, and will require re-provisioning by the utility.
•
Switch 1
– this small hole provides access to a reset switch for the WiFi radio. If
you insert a pen or paperclip wire to press and hold the internal switch for 5
seconds, it will reset the WiFi radio, and put it in AP/Router Mode. If the switch is
briefly pressed and not held, it will toggle the WiFi radio On/Off.