EAGLE-200
™
User Manual
6
Quick Setup
Step 1: Prerequisite software and hardware
1) A free Ethernet port, or WiFi access, on a router directly connected to the
internet.
2) A PC or other device with a web browser.
3) A utility meter with a certified Zigbee radio less than 100 feet from the
EAGLE-200.
Step 2: Register your EAGLE-200
Your EAGLE-200 device must be registered with your utility to connect to the
smart meter. You will need to contact your utility with two numbers (MAC
Address and Install Code) that can be found on the Information Label on the
underside of your EAGLE-200:
Note that it may take some time for your utility to enable the smart meter to
connect with your device. You must wait until this process is complete before
proceeding; your EAGLE-200 will not function correctly until the smart meter is
enabled.
Step 3: Power up your EAGLE-200
a) Plug the Ethernet cable into a port on your router, and the other end into the
Ethernet port on your EAGLE-200. It is also possible to connect wirelessly
using WiFi. If you wish to use WiFi, skip to the
WiFi Setup
section of this
manual.