EAGLE-200
™
User Manual
9
Step 2: Enable the WiFi radio
a) Your EAGLE-200 is shipped from the factory with the WiFi radio disabled. To
enable the WiFi radio, insert a pen or paperclip wire into the small hole
labeled “1” on the far left of the back of the EAGLE-200 and press and hold
the internal switch for 5 seconds.
b) It will take a minute for the WiFi radio to start up. Then you will see the center
status LED light at the front of the EAGLE-200 start flashing. This indicates
that the WiFi radio is active.
Step 3: Connect to WiFi
a) Now use your computer or phone equipped with WiFi to scan for WiFi access
points. In the list will be an entry for “eagle-xxxxxx (router)”, where xxxxxx is
the 6-digit Cloud ID for your EAGLE-200 (the Cloud ID can be found in the top
left corner of the device label). Click on this network to connect to it. When
prompted for the password, use the Install Code of the EAGLE-200 (Install
Code is a 16-
digit hexadecimal number shown as “IN:” on the EAGLE-200
label).
b) After you are connected to the EAGLE-200
WiFi, enter the address
192.168.7.1 into your web browser. This
will bring up the “Login” page.