USER MANUAL --Raiscube A8R 3D Printer
11
Fig.b21
STEP 2-3: Add Hotbed. We need hotbed plate(1pc), M3*25 screw (4pcs), M3 nut (4pcs) as
in Fig.b21. M3*25 screws insert from upper side and lock it with M3 nut from the other side. We
get in Fig.b22 when done here. And then, place hotbed over “H” plate, springs along each
screw and press down through holes against “H” plate, lock each screw from downside with
Knurl Nut. Please refer to Fig.b23 and Fig.b24 when doing.
PS: Heat bed power cord shall be on right (to connect to controller) when installed.
Fig.b21
Fig.22
Fig.b23
Fig.b24
