WWW.RAISE3D.COM
AMERICA · ASIA · EUROPE
5.
Double check that the new value has been changed to be 415.
•
Electronic Configuration
The stepper driver needs to be adjusted because we have changed the previous motor(s) to smaller
one(s) that requires a lower current. There is a risk that the motors will overheat and cause damage if
they are not adjusted.
You need:
-
A Multimeter
-
A Sharp tool
Depending on which cover your machine has, either use a sharp tool or a hex wrench to take the
cover off.
Installation Guide of BondTech
Single/
Dual Extruder (N-Series Printer Only)