RAISE 3D Pro2 Series Installation Instruction Download

Page: 1 / 4

WWW.RAISE3D.COM

AMERICA · ASIA · EUROPE

Pro2 Nozzle Installation Instruction

For the instructions on removing or re-installing the assembled hotend onto the extruder head, please

refer to the Manual Pro2

– 402 Hotend Replacement.

STEP 1:

Remove and install nozzle

1.1 Remove the old nozzle from heating block with an 8mm socket wrench.

To prevent damage to components, do not exert force on the throat rube. Hold from the solid section of the heating

block during adjustments.

1.2 Insert a cleaning rod completely through the hotend and ensure that tube is completely clear of

blockages,

Summary of Contents for Pro2 Series

Page 1: ...lease refer to the Manual Pro2 402 Hotend Replacement STEP 1 Remove and install nozzle 1 1 Remove the old nozzle from heating block with an 8mm socket wrench To prevent damage to components do not exe...

Page 2: ...ating block STEP 2 Tighten the Throat Tube Hold onto the heating block and tighten the throat tube by rotating the heat sink Rotate until the nozzle catches on to the tube begins to spin The heat sink...

Page 3: ...hten the nozzle completely using an 8mm socket wrench Check that a gap between the nozzle and the heating block has been maintained 3 2 Lie the hotend assembly on a flat surface rotating the heat sink...

Page 4: ...If you do not have a silicone sock adjust the heat sink so that it is flush with the bottom of the large cylinder 3 5 Install the new silicone cover onto the hot end For the steps of how to install th...