•
Insert the cables of the Heating Rod into the terminal and tighten the screws.
•
Ensure there are no exposed wires touching, as it may cause harm to the printer.(Note: You
can use a )flush cutter to straight the wires but do not cut them)
•
Insert the cables of the Thermocoupler into the terminal and tighten the screws.
•
Ensure there are no exposed wires touching on another, as it may cause harm to the printer.
•
Pay attention to the polarity. Red wire inserts to positive port, white wire inserts to negative
port.(Note: You can use a )flush cutter to straight the wires but do not cut them)
Version 1.0
Date：29/08/2018
6
www.raise3d.com
