Pro-Series
3D Printer
/ Quick Start Guide
B
Hardware Installation
Recommend to unclip the Zipties as you
are able to reuse the ties later.
1
3
Remove!
(×2)
Hex Wrench
(3 mm)
Use the 3mm hex wrench to remove the Z
axis clamps on both Z axis ball screws.
The 3mm hex wrench is packed inside the
tool box located inside the top foam.
Please remove the 24 clips holding the
extruder assembly in place before power-
ing on your printer. If you fail to remove
these clips your printer will be damaged.
Please save these clips and re-install them
if you transport your printer.
2
Remove!
(×24)
Remove!
Plug the machine into a wall outlet and
power on. The Power cable is packed
inside the tool box located inside the top
foam.
4