Version 1.0 Date
:
29/08/2018
- 3-
www.raise3d.com
Hold onto the heating block, and tighten the nozzle completely using an 8mm socket wrench. Check
that a gap between the nozzle and the heating block has been maintained,
STEP 5:
Adjust Heat Sink
Re-attach the silicone sock, then loosen the fixing screw on the heat sink.
Lie the hotend assembly on a flat surface, rotating the heat sink so that the fixing screw is facing outwards
.
Move the heat sink down so that it rests on the silicone sock, and tighten into place.
If you do not have a silicone sock, adjust the heat sink so that it is flush with the bottom of the large
cylinder.