Documentation Center
2. Cut off about 50 cm waterproof tape. Stretch it to double the length. Wrap three layers around the connector
with a 50% overlap. Hold the tape in place with your hand for a few seconds.
Figure 17: Wrapping with waterproof tape
3. Wrap three additional layers with PVC tape with natural uncoiling force and a 50% overlap. Make sure to cover
the head and the tail of the connector.
Figure 18: Final PVC wrapping
Solar Panel and Battery Kit Installation
This document shows the step-by-step guide on how to set-up the Solar Panel and Battery Kit used for the
RAK7249 - Macro Outdoor Gateway. Such steps must be thoroughly read and understood to avoid damaging the
device.
Package List
