RAMPAGE NAVIGATION HANDLEBAR CONTROLLER
Version 1.7.3
On the other side of the unit is the exposed
micro USB slot. This must not be covered
as this is used for programming the board
as well as powering the unit. This is also
where you can do the permanent power
option using this USB plug. The USB gap
is extra large to allow the USB cable to go
‘into’ the box and to not damage the USB
plug from riding with minor movements.
We use a normal CAT5 network cable as
the tether between the boxes as it already
has the minimum required 8 strands that
the controller needs.
TIP!
A good tip is to place a network
female-female adapter in the middle. This
makes it very convenient to unplug one
portion from the other. Especially if the unit
is fitted onto the bike. You can remove
separate sections for field replacement or
repairs.
Copyright © Rally Rampage & Eugene Beetge 2022
Page 10