Towing Condition
Wheels OFF The Ground
Two-Wheel Drive Models
Four-Wheel Drive Models
Flat Tow
NONE
NOT ALLOWED
See Instructions
●
Transmission in PARK
●
Transfer case in N (Neutral)
●
Tow in forward direction
Dolly Tow
Front
NOT ALLOWED
NOT ALLOWED
Rear
OK
NOT ALLOWED
On Trailer
ALL
OK
OK
198 STARTING AND OPERATING
NOTE:
Detach the snowplow when transporting passengers.
Vehicle front end wheel alignment was set to specifi-
cations at the factory without consideration for the weight
of the plow. Front end toe-in should be checked and reset
if necessary at the beginning and end of the snowplow
season. This will help prevent uneven tire wear.
The blade should be lowered whenever the vehicle is
parked.
Maintain and operate your vehicle and snowplow
equipment following the recommendations provided by
the specific snowplow manufacturer.
O
VER
T
HE
R
OAD
O
PERATION
W
ITH
S
NOWPLOW
A
TTACHED
The blade restricts air flow to the radiator and causes
the engine to operate at higher than normal
temperatures. Therefore, when transporting the plow,
angle the blade completely and position it as low as
road or surface conditions permit. Do not exceed 40
When plowing snow, to avoid transmission and
drivetrain damage, the following precautions should be
observed:
●
Operate with transfer case in 4WD LOW when
plowing small or congested areas where speeds are
not likely to exceed 15 mph (24 km/h). At higher
speeds operate in 4WD HIGH.
●
Vehicles with automatic transmissions should use
4WD LOW when plowing deep or heavy snow for
extended periods of time to avoid transmission
overheating.
●
Do not shift the transmission unless the engine has
returned to idle and wheels have stopped. Make a
practice of stepping on the brake pedal while shifting
the transmission.
mph (64 km/h). The operator should always maintain a
safe stopping distance and allow adequate passing
clearance.
NOTE:
Lane Departure Warning / Lane Keep Assist is not
available when a snow plow is attached.
O
PERATING
T
IPS
Under ideal snow plowing conditions, 20 mph (32 km/
h) should be maximum operating speed. The operator
should be familiar with the area and surface to be
cleaned. Reduce speed and use extreme caution when
plowing unfamiliar areas or under poor visibility.
G
ENERAL
M
AINTENANCE
Snowplows should be maintained in accordance with
the plow manufacturer's instructions.
Keep all snowplow electrical connections and battery
terminals clean and free of corrosion.
RECREATIONAL TOWING (BEHIND
MOTORHOME)
T
OWING
T
HIS
V
EHICLE
B
EHIND
A
NOTHER
V
EHICLE
