J
ACK
L
OCATION
The jack and tools are stored under the front passenger
seat.
R
EMOVAL
O
F
J
ACK
A
ND
T
OOLS
To access the jack and tools, you must remove the
plastic access cover located on the side of the front
passenger’s seat. To remove the cover, pull the front
part of the cover (closest to the front of the seat) toward
you to release a locking tab. Once the front of the cover
is loose, slide the cover toward the front of the seat
until it is free from the seat frame.
Pull Jack Access Cover From Front
Remove the jack and tools by turning the wing bolt
counterclockwise. After removing the wing bolt, slide
the assembly out from under the seat.
Jack And Tools
Release the tool bag straps from the jack and remove
tools from bag.
Jack And Tool Bag
286 IN CASE OF EMERGENCY
There are two ways to assemble the tools:
Assembled For Spare Tire Lowering/Raising
Assembled For Spare Tire Lowering/Raising
1 — Lug Wrench
2 — Long Extension Without Spring Clip #2
3 — Long Extension With Spring Clip #3
4 — Long Extension With Spring Clip #4
5 — Short Extension #5
NOTE:
If the tailgate is lowered, adding the shorter extension
#5 to jack extension #4 will enable lowering the spare
tire without having to raise the tailgate.
CAUTION!
●
The lug wrench can only be attached to extension
#2.
●
When attaching the tool to the winch mechanism
be sure the large flared end opening on
extension #4 is positioned correctly over the winch
mechanism adjusting nut.
(Continued)
