P
ARK
S
ENSE
A
UTOMATED
P
ARKING
— I
F
E
QUIPPED
Parallel/Perpendicular Parking Space
Assistance Operation
When the ParkSense Active Park Assist system is
enabled, the driver must press “Park” on the Uconnect
display, activate turn signal on either the left or right
side, and the system will begin searching for valid
parallel and perpendicular parking spaces.
NOTE:
●
The driver needs to make sure that the selected
parking space for the maneuver remains free and
clear of any obstructions (e.g. pedestrians, bicycles,
etc.).
●
The driver is responsible to ensure that the selected
parking space is suitable for the maneuver and
free/clear of anything that may be overhanging or
protruding into the parking space (e.g., ladders,
tailgates, etc. from surrounding objects/vehicles).
●
When searching for a parking space, the driver
should drive as parallel or perpendicular (depending
on the type of maneuver) to other vehicles as
possible.
●
While the vehicle is in DRIVE, there will be a full
screen image in the Uconnect display. If the driver
shifts to REVERSE while searching for a parking
space, a camera image will appear in the Uconnect
display with a “Shift To Drive” message.
Both types of valid spaces (parallel and perpendicular)
will be displayed in the Uconnect display as they are
found. The available spaces will update in real time.
The Fully Automated system will detect a vacant parking
spot between two consecutive parking lines.
When valid parking spaces have been found, the driver
will be prompted to stop the vehicle.
Select A Space
The driver can then select a parking space by pressing
the desired space on the Uconnect display.
NOTE:
If a space selection is attempted before the vehicle is
stopped, a warning screen will appear in the Uconnect
display with instructions to stop the vehicle to make a
selection.
If the driver selects a perpendicular parking space, the
system will prompt the driver to choose a Forward or
Reverse parking method.
Choose Perpendicular Parking Method
NOTE:
You can press the “Back” button on the display to
return to the parking space selection screen and select
a different space.
Once the parallel or perpendicular parking maneuver
selection has been made, a message will appear in
the display with instructions to hold down the Active
Park Assist switch. This conditions must be met in
order to begin the parking maneuver. The message also
instructs the driver to hold the Active Park Assist switch
down for the entire maneuver.
The system will then instruct the driver to remove hands
from the steering wheel and feet from the pedals. This
screen will be shown for a minimum of two seconds, or
until the driver releases the brake pedal.
When the parking sequence is initiated by the driver
after the previously described conditions are met, the
Uconnect system will display a Top View along with
either a rear camera view (if the vehicle is placed in
REVERSE) or a forward camera view (if the vehicle is
placed in DRIVE).
160 STARTING AND OPERATING
