1. Push the Active Driving Assist on/off button
located on the right side of the steering wheel.
The steering wheel image will display white in
the instrument cluster display until the system is
engaged. If ACC was previously disabled, pushing
this button will activate BOTH ACC and Active
Driving Assist systems.
2. If ACC was engaged before pushing the ADA on/off
button, ACC will remain active and ADA will also
become engaged (once all other conditions are
met).
3. If ACC was not active before pushing the ADA
on/off button, push the SET (+) button or the SET
(-) button and release when the desired driving
speed is shown in the instrument cluster display.
4. If desired, adjust the ACC distance setting
by pushing the Distance Increase or Distance
Decrease buttons.
When all system conditions are met as described in
“System Engagement Conditions” in the next section,
the system will engage and the steering wheel image in
the display will change to green.
Active Driving Assist
Engaged (Steering Wheel Green)
System Engagement Conditions
The following conditions must be met before the system
will engage and will NOT be shown in the ADA status
message location:
●
Active Driving Assist system is enabled (white ADA
status icon)
●
Turn signal is not activated
●
Driver seat belt is buckled
●
Driver door is closed
●
Driver is not pressing the brake pedal
●
Driver has hands on steering wheel
The following conditions must be met before the system
will engage and WILL be shown in the ADA status
message location:
●
System detects visible lane markings
●
Vehicle is traveling below 90 mph (145 km/h)
●
Vehicle is centered in lane
●
Vehicle is not in a tight curve
●
Trailer is not connected
NOTE:
For the system to detect the driver’s hands on the
steering wheel, the wheel must be gripped on the
outside. Gripping the inside areas of the steering wheel
will not satisfy the hands-on condition to engage the
system.
Do Not Grip Inside Of Steering Wheel
System Deactivation
The system will be deactivated in any of the following
situations:
●
The system initiates a Stop-In-Lane maneuver to stop
the vehicle due to driver inattentiveness. The Stop-In-
Lane maneuver can be overridden by placing hands
on the steering wheel and applying the accelerator or
brake pedal. Refer to “Indications On The Display” in
the next section for further information
●
If lane markings are no longer detected or poor road
conditions are experienced
STARTING AND OPERATING 167
4
