●
The Top View will show which doors are open.
●
Open front doors will block the outside image.
Top View Plus Rear View
This is the default view of the system in
REVERSE and is always paired with the
Top View of the vehicle with optional active
guidelines for the projected path when
enabled.
Rear Cross Path View
Pressing the Rear Cross Path button will
give the driver a wider angle view of the
rear camera system. The Top View will be
disabled when this is selected.
Top View Plus Front View
Pressing the Front View button will show you
what is immediately in front of the vehicle
and is always paired with the Top View of
the vehicle.
Front Cross Path View
Pressing the Front Cross Path button will
give the driver a wider angle view of the
front camera system. The Top View will be
disabled when this is selected.
Back Up Camera View
Pressing the Back Up Camera button will
provide a full screen rearview with the ability
to access a Zoom View.
NOTE:
●
If the Back Up Camera was selected through the
Surround View Camera menu, exiting out of screen
display will return to the Surround View menu. If the
Back Up Camera was manually activated through the
Camera menu of the Uconnect system, exiting out of
the display screen will return to the Camera menu.
●
When the Trailer Reverse Steering Control (TRSC)
feature (if equipped) is activated, the following
buttons on the touchscreen will be unavailable:
○
Back Up Camera
○
Front Facing Camera with Tire Lines
○
All Surround View Camera Views
Zoom View
When the Rear View Camera image is being displayed,
and the vehicle speed is below 8 mph (13 km/h), Zoom
View is available. By pressing the “magnifying glass”
icon in the upper left of the display screen, the image
will zoom in two times the standard view. Pressing the
icon a second time will return the view to the standard
Back Up Camera display.
When Zoom View is selected while the vehicle is in
REVERSE, then shifted to DRIVE, the camera delay view
will display the standard Back Up Camera view. If the
vehicle is then returned to REVERSE gear from DRIVE,
the Zoom View selection will automatically resume.
Shifting to NEUTRAL from any gear will maintain the
selected view (Zoom or Standard) as long as the vehicle
is below 8 mph (13 km/h).
If the vehicle is in PARK, Zoom View is available until
the gear selector is placed in DRIVE or REVERSE and
speeds are at or above 8 mph (13 km/h).
NOTE:
●
If the vehicle is in DRIVE, NEUTRAL, or REVERSE, and
speed is greater than or equal to 8 mph (13 km/h),
Zoom View is unavailable and the icon will appear
grey.
●
While in Zoom View, the guidelines will not be visible.
Deactivation
The system is deactivated in the following conditions if
it was activated automatically:
●
When the vehicle is shifted out of REVERSE with
camera delay turned on, the camera image will
continue to be displayed for up to 10 seconds after
shifting out of REVERSE unless the vehicle speed
exceeds 8 mph (13 km/h), the vehicle is shifted into
PARK or the ignition is placed in the OFF position.
There is a touchscreen X button to disable the
display of the camera image.
●
When the vehicle is shifted out of REVERSE with
camera delay turned off, the Surround View Camera
mode is exited and the last known screen appears
again.
The system is deactivated in the following conditions if
it was activated manually from the Uconnect Camera
menu via Surround View button or Back Up Camera
button:
●
The touchscreen X button is pressed
●
Vehicle is shifted into PARK
●
Ignition is placed in the OFF position
●
Vehicle speed is over 8 mph (13 km/h) for 10
seconds
NOTE:
If the Surround View Camera is activated manually,
and the vehicle is shifted into REVERSE, deactivation
methods for automatic activation are assumed.
180 STARTING AND OPERATING
