14
GETTING TO KNOW YOUR VEHICLE
KEYS
K
EY
F
OBS
Your vehicle uses a wireless ignition node system
that consists of a key fob and Keyless Enter-N-Go
button.
NOTE:
The key fob may not be detected if it is located next
to a mobile phone, laptop, cell phone charging
cable source, or other electronic device; these
devices may block the key fob’s wireless signal.
WIN Key Fob With Integrated Key
The wireless ignition node key fob operates the
ignition switch. Insert the square end of the key fob
into the ignition switch located on the instrument
panel and rotate to the desired position. It also
contains the key fob and an emergency key, which
stores in the rear of the key fob.
The emergency key allows for entry into the vehicle
should the battery in the vehicle or the key fob
become depleted. You can keep the emergency
key with you when valet parking.
To remove the emergency key, slide the
mechanical latch at the top of the key fob sideways
with your thumb and then pull the key out with your
other hand.
Key Fob Emergency Key
NOTE:
When using the emergency key to gain access to
your vehicle, be aware that the security alarm may
be triggered. Insert the key into the ignition and
place the ignition in the ON/RUN mode to disarm
the security system.
The Remote Keyless Entry system allows you to
lock or unlock all doors, tailgate, and the RamBox
(if equipped) as well as activate the Panic Alarm
from distances up to approximately 66 ft (20 m)
using a key fob with integrated key. The key fob
does not need to be pointed at the vehicle to
activate the system. Push and release the lock
button on the key fob to lock all doors, the tailgate
and the RamBox (if equipped). The turn signal
lights will flash and the horn will chirp to
acknowledge the signal (if programmed in
Uconnect Settings).
NOTE:
Inserting the key fob with integrated key into the
ignition switch disables the system from
responding to any button pushes from that key fob.
Driving at speeds 5 mph (8 km/h) and above
disables the system from responding to all key fob
buttons for all key fobs.
To Unlock The Doors And Tailgate
Push and release the unlock button on the key fob
once to unlock the driver’s door. Push the unlock
button twice within five seconds to unlock all
doors, the tailgate and the RamBox (if equipped).
The turn signal lights will flash to acknowledge the
unlock signal. The illuminated entry system will
also turn on.
NOTE:
The “1st Press Of Key Fob Unlock” feature lets you
program the system to unlock either the driver's
door or all doors on the first push of the unlock
button on the key fob. You can adjust the setting in
the instrument cluster display or Uconnect
Settings.
20_DS_OM_EN_USC_t.book Page 14
