GETTING TO KNOW YOUR VEHICLE
63
Outside Air Intake
Make sure the air intake, located directly in front of
the windshield, is free of obstructions, such as
leaves. Leaves collected in the air intake may reduce
airflow, and if they enter the plenum, they could plug
the water drains. In Winter months, make sure the
air intake is clear of ice, slush, and snow.
Cabin Air Filter
The Climate Control system filters out dust and
pollen from the air. Contact an authorized dealer to
service your cabin air filter, and to have it replaced
when needed.
Operating Tips Chart
WINDOWS
P
OWER
W
INDOWS
— I
F
E
QUIPPED
Power Window Switches
The power window controls located on the driver's
door trim panel have up-down switches that give
you fingertip control of all power windows. There is
a single opening and closing switch on the front
passenger door and the rear doors for passenger
window controls. The windows will operate when
the ignition switch is placed in the ACC or ON/RUN
position, and for up to 10 minutes after the ignition
is placed in the OFF position or until a front door is
opened.
CAUTION!
Failure to follow these cautions can cause
damage to the heating elements:
Use care when washing the inside of the rear
window. Do not use abrasive window cleaners
on the interior surface of the window. Use a
soft cloth and a mild washing solution, wiping
parallel to the heating elements. Labels can
be peeled off after soaking with warm water.
Do not use scrapers, sharp instruments, or
abrasive window cleaners on the interior
surface of the window.
Keep all objects a safe distance from the
window.
WEATHER
CONTROL SETTINGS
Hot Weather And
Vehicle Interior Is Very
Hot
Set the mode control to
, on, and blower
on high. Roll down the
windows for a minute
to flush out the hot air.
Adjust the controls as
needed to achieve
comfort.
Warm Weather
Turn on and set the
mode control to the
position.
Cool Sunny
Operate in position.
Cool & Humid
Conditions
Set the mode control to
and turn on to
keep windows clear.
Cold Weather
Set the mode control to
the position. If
windshield fogging
starts to occur, move
the control to the
position.
2
20_DS_OM_EN_USC_t.book Page 63
