Tether Anchorage Installation
Regular and Mega Cab Trucks:
In the regular cab truck, the top tether anchorages are located behind the center and
right passenger seats. In the mega cab truck, the top tether anchorages are located
behind each rear seating position. There is a plastic cover over each anchorage.
To attach the tether strap of the child restraint:
1. Place the child restraint on the seat and adjust the tether strap so that it will reach
over the seat back, under the head restraint and to the tether anchor directly
behind the seat.
2. Route the tether strap to provide the most direct path between the anchorage and
the child seat. The tether strap should go between the head restraint posts
underneath the head restraint. You may need to adjust the head restraint to the
upward position to pass the tether strap underneath the head restraint and
between its posts.
3. Lift the cover (if equipped) and attach the hook to the square opening in the sheet
metal. Tighten the tether strap according to the child seat manufacturer’s
instructions.
Quad or Crew Cab Trucks:
The top tether anchorages in this vehicle are tether strap loops located between the
rear glass and the back of the rear seat. There is a tether strap loop located behind
each seating position. Follow the steps below to attach the tether strap of the child
restraint.
Right or Left Outboard Seats:
1. Raise the head restraint and reach between the rear seat and rear glass to access
the tether strap loop.
2. Place a child restraint on the seat and adjust the tether strap so that it will reach
over the seat back, under the head restraint, through the tether strap loop behind
the seat and over to the tether strap loop behind the center seat.
Head Restraint In Raised Position
Tether Strap Loop With Center Head
Restraint In Raised Position
G E T T I N G S T A R T E D
24
Summary of Contents for 2015 1500
