GETTING TO KNOW YOUR VEHICLE
12
To Lock The Doors And Tailgate
Push and release the lock button on the key
fob to lock all doors, the tailgate, and the
RamBox (if equipped). The turn signal lights
will flash and the horn will chirp to acknowl
-
edge the signal.
Air Suspension (Remote Lowering Of The
Vehicle) — If Equipped
For easy entry and loading, your
vehicle can be lowered by pushing
the key fob air suspension lowering
button two times. When key fob
lowering is requested, the vehicle will send a
series of chirps and flashes to alert the
customer that the operation has begun and
will continue these alerts until it successfully
lowers.
The following conditions must be met for the
vehicle to lower remotely:
The vehicle must not already be in Entry/
Exit (Park) ride height.
The vehicle battery must be fully charged.
All doors must be closed.
The key fob must be out of the vehicle.
Canceling Remote Lowering
Vehicle lowering can be cancelled at
anytime. When vehicle lowering is canceled,
the vehicle will raise up to the next defined
level and lock out the remote lowering
feature until the ignition has been cycled
ON/OFF.
To cancel vehicle lowering, push the key fob
air suspension lowering button one time
during the lowering process. When vehicle
lowering is canceled, the horn will chirp two
times and the turn signal lamps will flash
four times. Once raising is completed, the
horn will chirp one time.
NOTE:
Refer to “Air Suspension System” in
“Starting And Operating” for further informa
-
tion.
General Information
The following regulatory statement applies to
all radio frequency (RF) devices equipped in
this vehicle:
This device complies with Part 15 of the FCC
Rules
and
with
Industry
Canada
license-exempt RSS standard(s). Operation
is subject to the following two conditions:
1. This device may not cause harmful inter
-
ference, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE:
Changes or modifications not expressly
approved by the party responsible for compli
-
ance could void the user’s authority to
operate the equipment.
IGNITION SWITCH
Keyless Push Button Ignition
This feature allows the driver to operate the
ignition switch with the push of a button as
long as the Remote Keyless Entry key fob is
in the passenger compartment.
The Keyless Push Button Ignition has four
operating positions; three of which are
labeled and will illuminate when in position.
The three positions are OFF, ACC, and ON/
RUN. The fourth position is START, during
start RUN will illuminate.
2019_RAM_2500_3500_UG_USA=GUID-8BBFE451-BF24-4E82-808A-AE2460D39A05=1=en=.book Page 12
Summary of Contents for 2500 2019
Page 1: ...2019 USER GUIDE RAM 2500 3500...
Page 330: ......
