151
To exit ERS mode, simply push and hold the
ERS (+) switch until the gear limit display
disappears from the instrument cluster.
NOTE:
To select the proper gear position for
maximum deceleration (engine braking),
simply push and hold the ERS (-) switch. The
transmission will shift to the range from
which the vehicle can best be slowed down.
FOUR-WHEEL DRIVE
OPERATION — IF EQUIPPED
Four-wheel drive trucks are equipped with
either a manually shifted transfer case or
an electronically shifted transfer case.
Refer to the operating instructions for
electronic transfer case, located in this
section for further information.
For further information on the manually
shifted transfer case, refer to “Four Wheel
Drive Operation” in “Starting And Oper
-
ating” in your Owner’s Manual.
Four-Position Electronically Shifted
Transfer Case — If Equipped
This is an electronic shift transfer case and
is operated by the 4WD Control Switch
(Transfer Case Switch), which is located on
the instrument panel.
Four-Position Transfer Case
This electronically shifted transfer case
provides four mode positions:
Two-Wheel Drive High Range (2WD)
Four-Wheel Drive High Range (4WD
HIGH)
Four-Wheel Drive Low Range (4WD LOW)
Neutral (NEUTRAL)
For additional information on the appropriate
use of each transfer case mode position, see
the information below:
WARNING!
Do not downshift for additional engine
braking on a slippery surface. The drive
wheels could lose their grip and the
vehicle could skid, causing a collision or
personal injury.
Transmis
-
sion Gear
Limit
Display
1 2 3 4 5 6 D
Actual
Gear(s)
Allowed
1 1-2 1-3 1-4 1-5 1-6 1-6
CAUTION!
When using ERS for engine braking while
descending steep grades, be careful not to
overspeed the engine. Apply the brakes as
needed to prevent engine overspeed.
2019_RAM_2500_3500_UG_USA=GUID-8BBFE451-BF24-4E82-808A-AE2460D39A05=1=en=.book Page 151
Summary of Contents for 2500 2019
Page 1: ...2019 USER GUIDE RAM 2500 3500...
Page 330: ......
