STARTING AND OPERATING
166
Manual Activation Of The Rear View Camera:
1. Press the "Controls" button located on
the bottom of the Uconnect display.
2. Press the "Backup Camera" button to
turn the Rear View Camera system on.
When the vehicle is shifted out of REVERSE
(with Camera delay turned off), the rear
Camera mode is exited and the previous
screen appears again.
When the vehicle is shifted out of REVERSE
(with Camera delay turned on), the rear
Camera image will be displayed for up to 10
seconds after shifting to another gear, unless
the vehicle speed exceeds 8 mph (13 km/h),
the transmission is shifted into PARK, the
ignition is placed in the OFF position, or the
touchscreen button “X” to disable display of
the Rear View Camera image is pressed.
Whenever the Rear View Camera image is
activated through the "Backup Camera"
button in the "Controls" menu, and the
vehicle speed is greater than, or equal to,
8 mph (13 km/h), a display timer for the
image is initiated. The image will continue to
be displayed until the display timer exceeds
10 seconds.
NOTE:
If the vehicle speed remains below 8 mph
(13 km/h), the Rear View Camera image
will be displayed continuously until deac
-
tivated via the touchscreen button "X", the
transmission is shifted into PARK, or the
ignition is placed in the OFF position.
The touchscreen button "X" to disable
display of the camera image is made avail
-
able ONLY when the vehicle is not in
REVERSE.
Backup
Camera
Touchscreen
Button
Cargo Camera Touchscreen Button
AUX Camera Touchscreen Button
If equipped with a Cargo Camera, a touch
-
screen button
to indicate the current
active Camera image being displayed is
made available whenever the Rear View
Camera image is displayed.
If equipped with a Cargo Camera, a touch
-
screen button
to switch the display to
Cargo Camera image is made available when
-
ever the Rear View Camera image is
displayed.
A touchscreen button "X" to disable display
of the camera image is made available when
the vehicle is not in REVERSE gear.
When enabled, active guide lines are overlaid
on the backup camera image to illustrate the
width of the vehicle and its projected backup
path based on the steering wheel position.
The active guide lines will show separate
zones that will help indicate the distance to
the rear of the vehicle.
NOTE:
For further information about how to access
and change the programmable features of
the ParkView Rear Backup Camera, refer to
“Uconnect Settings ” in “Multimedia” in the
Owner’s Manual.
2019_RAM_2500_3500_UG_USA=GUID-8BBFE451-BF24-4E82-808A-AE2460D39A05=1=en=.book Page 166
Summary of Contents for 2500 2019
Page 1: ...2019 USER GUIDE RAM 2500 3500...
Page 330: ......
