9
ADAPTING THE COOKTOP FOR DIFFERENT TYPES OF GAS
To adapt the cooktop to a different type of gas than th
at for which it was designed,
(see the sticker under the hob or on the package), the burner nozzles must be changed, as follows:
Remove the pan supports and slide the burners out of the cooktop.
Unscrew the nozzles using a 7mm socket wrench and replace them with those for the new
type of gas.
Reassemble the parts following the instructions in reverse order.
On completing the operation, replace the old rating label with the one showing the new
type of gas; the sticker is available from our SERVICE CENTRES.
If the gas pressure is different than that prescribed, a pressure regulator must be installed
at the source, in compliance with national standards government the use of piped gas
regulators.
To complete the conversion, follow up below,
Replacement of the burner injectors
Regulation of the burner flame level
Leak test
Replacement of the burner injectors
Inside the box there is one pair of gas burner jets for opposite gas type, sealed in a small bag.
Remove the gratings and the burner covers;
Using a wrench, substitute the nozzle injectors; “J” (Fig.8) with the
pair provided in the small bag
.
Regulation of the burner flame level
Regulation of the burner flame level; when switching from one type of gas to another, the minimum
flow rate must be adjusted so the flame should not go out. To regulate the flame follow;
Light up the burner
