12
Then flip the bike upside down so that the bike is resting on the seat and the handlebars. Loosen the axle nuts
from the axle, then put the wheel into the fork making sure the anti-turn washer is on the inside of the fork,
and the tab on the anti-turn washer is locked into place on the fork dropout as shown below. The motor
power wire should be facing down (with the bike upside down, or facing up, when the bike is upright). Once
the wheel, anti-turn washers and brake rotor are aligned on the fork tighten both axle nuts.
Use a 19mm wrench to tighten the axle nuts firmly. As shown below.
Summary of Contents for R1000X2M-FF-BFD
Page 9: ...9 IDENTIFYING BIKE PARTS...
Page 23: ...23 TROUBLESHOOTING GUIDE Error Codes...
Page 25: ...25...
