22
Storage:
Always store the battery in a dry place with temperature above freezing and below 113 degrees Fahrenheit
(45 Celsius)
It is best practice to store the battery with a charge above 50%
To extend the life of your battery it is best to discharge and charge every 3 months.
INSPECTION BEFORE EVERY RIDE
Before every ride, inspect the bike with the following check list. If any part of the bike fails the inspection,
repair the bike by following the information provided in this manual or take the bike to your bike shop for
service. Never ride a bike with a damaged part; have it replaced.
Tires and Wheels
-Spin each wheel and check that the tires are in good shape with no cuts or abrasions. If these are found,
replace the tire immediately.
-Inspect the rim for trueness by spinning it and watching for any side-to-side or up-and-down wobble. If any
movement is noted do not ride this bike until the rim is repaired
-Check the tire inflation. Make sure to check tire pressures using a tire pressure gauge. The tires should be set
between 10psi and 25psi.
NEVER SET TIRE PRESSURE BELOW 10PSI OR ABOVE 25PSI
A WHEEL ATTACHMENT DEVICE THAT IS NOT PROPERLY ADJUSTED AND CLOSED MAY ALLOW THE WHEEL
TO BE LOOSE OR COME OFF UNEXPECTIDLY, CAUSING YOU TO LOSE CONTROL AND FALL. MAKE SURE THE
WHEELS ARE PROPERLY ATTACHED BEFORE RIDING THE BIKE.
Wheel Retention System:
-Your bike comes with a thru axle front axle, make sure the front tire is centered on the fork. Once centered,
insert the thru axle, and tighten the axle. After the axle is tightened then tighten the pinch bolts.
-Check that the disc brake operates properly.
-Illustration below shows the correct tightening of the front wheel.
