Anchor Panels
Fasten to Insert Channel
Anchor side panels to floor through holes in the
door post footplate using supplied concrete anchors.
Pilot holes for the anchors should be 7/16” diameter
and 5 1/4” deep (1/4” deeper than anchor).
Fasten side panels to the insert channels using
supplied “Clip Screws” through holes in side panel.
It is recommended to pre-drill 1/8” dia. holes at
each hole location.
Clip Screw
Install Boards into Stall Fronts
2 x 6 tongue and groove boards are recommended.
Cut boards to length to fit inside the channels (approx. 47”).
Slide boards into channels using a rubber mallet to secure
each board into place.
The tongue should be ripped off the last two boards in order
to fit into place.
NOTE: The last board may need to be ripped down to fit.
Fasten the last two boards in place from the front side using
supplied SS1 screws through holes in the bottom channel.
Place the wood cover plate over the cutout in the bottom
channel on the back of each stall front panel and fasten
to boards with supplied SS1 screws.
SS1 Screw
Tuscany Stall Front Installation Instructions