Install Wood into Door
2 x 6 tongue and groove boards are recommended.
Wood Doors with Arrows:
Grilled Doors with Arrows:
Cut boards to length and slide into channels using a rubber
mallet to secure into place.
The tongue and groove should be ripped off the last two
boards in order to fit into place.
NOTE: The last board may need to be ripped down to fit.
Fasten boards into place from the front using supplied SS1
screws through holes in channel.
Place wood cover plate over cutout in the bottom channel
on the back of each door and fasten with supplied SS1 screws.
Cut horizontal boards to length and fit into “arrow” openings.
Fasten with SS1 screws through holes in “arrows” in front of door.
NOTE: Drilling pilot holes in boards will reduce splitting.
Cut horizontal boards to length and fit into “arrow” openings.
Fasten with SS1 screws through holes in “arrows” in front of door.
NOTE: Drilling pilot holes in boards will reduce splitting.
SS1 Screw
Tuscany Stall Front Installation Instructions
