Attach Hinges
Locate hinge hardware that was shipped with order.
Subassembly B
Subassembly A
Door Hinge Bracket
(welded to door)
Post Hinge Bracket
(welded to post)
Attach hinge assembly to post hinge bracket as shown.
Using a wrench and “blocking pin”, tighten nut.
The “blocking pin” (not supplied) can be a narrow punch,
screwdriver or heavy nail.
Note: The item used as the “blocking pin” may get bent
during tightening.
Remove nut and washer on Subassembly B.
Slide door onto Subassembly B and attach
washer and nut.
1/2”
1/2”
Adjust hinges to achieve approximately
1/2” equal spacing on both sides of door.
Tuscany Stall Front Installation Instructions
Blocking Pin
