11
III. OPERATION
FILLING AND DUMPING A BUCKET
1.
Approach the pile with the lift arms fully
down and bucket cutting edge just
skimming the top of the ground as in
Figure 10.
2.
As soon as the bucket is full, tilt bucket
back and back away from the pile, as
shown in Figure 11 and 12.
3.
When dumping, raise bucket high
enough to clear stockpile or sides of
container being loaded.
4.
Drive slowly forward until bucket is
over dumping area and tilt bucket
forward until it completely empties.
5.
Tilt bucket, back up if necessary to clear
container side and back away.
WARNING
Use Extreme Caution When Stopping. If
The Bucket Or Attachment Is Raised The
Machine Can Tip. Keep All Movements
Smooth and Gradual When Maneuvering
With Lift Arms Raised. Do Not Cross
Obstructions With Arms Raised. All New
Operators Must Work The Machine In A
Safe Open Area To Become Familiar With
Its Operating Characteristics.
WARNING
Never Step Off The Operator Platform With
The Load Raised
DIGGING WITH A BUCKET
1.
Lower lift arms fully and tilt bucket
forward until cutting edge is on the
ground.
2.
Drive Machine forward slowly and
continue to tilt bucket forward until it
enters the ground to desired depth and
then tilt it back a small amount to keep
an even depth, as show in Figure 13.
3.
Continue driving forward until
bucket is full and then tilt bucket
fully back while driving slowly
forward or stopping the machine.
Figure 11
Figure 12
Figure 13
Figure 14
LEVELING
1.
To spread material on uneven
ground, raise lift arms and tilt
bucket forward while driving
slowly forward, as shown in
Figure 14.
