- 011 -
Angle Grinder18V
Owners Manual
English | 27
Bosch Power Tools
1 609 92A 47F | (14.11.17)
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN
60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or insertion tools or is
poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working
period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work pat-
terns.
Fitting
Charging the
Battery
Use only the battery chargers listed on the accessories
page. Only these battery chargers are matched to the lith-
ium-ion battery of your power tool.
Note: The battery supplied is partially charged. To ensure full
capacity of the battery, completely charge the battery in the
battery charger before using your power tool for the first time.
The lithium-ion battery can be charged at any time without re-
ducing its service life. Interrupting the charging procedure
does not damage the battery.
The lithium-ion battery is protected against deep discharging
by the “Electronic Cell Protection (ECP)”. When the battery is
empty, the machine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
Do not continue to press the On/Off switch after the
machine has been automatically switched off. The bat-
tery can be damaged.
Follow the instructions on correct disposal
.
Removing the battery
The battery
5
is equipped with two locking levels that should
prevent the battery from falling out when pushing the
battery unlocking button
6
unintentionally. As long as the
battery is inserted in the power tool, it is held in position by
means of a spring.
To remove the battery
5
, press the unlocking button
6
and
pull out the battery toward the front. Do not exert any force.
OBJ_BUCH-3456-001.book Page 27 Tuesday, November 14, 2017 1:42 PM
